Some files in the project contain chinese characters. But why do I get these errors? Is it because I changed the Toolchain?Īlso, why error, I mean, do I need something special to use`log()`? I do know that this project can be compiled I also received the cyacd file. Build error: The command 'arm-none-eabi-gcc.exe' failed with exit code '1'.Įrror and are the ones in the previous quote block. Build error: undefined reference to `log' Build error: region `rom' overflowed by 0 bytes cyloadablemeta loaded at overlaps section. ProjectName.cydsn\CortexM3\ARM_GCC_541\Debug\ ProjectName.elf section `.eh_frame' will not fit in region `rom' The frequency calculation depends on several variables, so it’s ideal to check the values in an emulator first and refine the system if necessary. ProjectName.cydsn\CortexM3\ARM_GCC_541\Debug\ ProjectName.elf section `.text' is not within region `rom' Here’s a basic graphical explanation Note the output of the variables (the duty cycle and frequency) in the emulator of Keil’s ARM IDE. When I change it to ARM GCC -q2-update, the "Output" tab does act more lively.
I can change it to ARM GCC -q2-update or ARM GCC Generic. If I go to Project > Build Settings > Toolchain, it tells me " ARM MDK Generic" Use Tools > Options > Project Management > Generic Toolchains to set the location of the appropriate binaries The tool chain will not build until a location is selected. Use Tools > Options > Project Management > Generic Toolchains to set the location of the appropriate binaries.īuild error: ERROR: No location was selected for the binaries of the tool chain "ARM MDK Generic". No location was selected for the binaries of the tool chain "ARM MDK Generic". However, after pressing F6, I'm getting the Errors:
I downloaded PSoC Creator 4.2 and installed it on a clean pc (no PSoC installed prior on it).Īfter opening the project, I updated a couple of components(?), of which the IDE told me an update was available. Question: Is there any downside to installing a newer version of PSoC Creator
I was advised to install PSoC Creator 3.3 dp1 Question: Is Keil the only compiler I can use, or are there other (free / better / cheaper) compilers that I can use? The paid version is quite expansive, and its unclear to me what paid version I would require. However, when I set the path, it returns a message that the limit of 32KB is exceeded. At the Samsung Foundry Forum, Arm, in a joint effort with Samsung Foundry, Cadence, and Sondrel, showed the first 28nm fully-depleted silicon-on-insulator (FD-SOI) embedded MagnetoResistive Random Access Memory (eMRAM) IoT test chip and advancement board. Running F6 results in the same error as stated in this question: Cannot find Generated_SourcesĪfter some searching, I found that "Keil" provides a compiler. ARM’s Musca-S1 test chip demonstrates a new choice in SoC design for IoT solutions. I installed "PSoCCreatorSetup_3.3_dp1_b9674.exe" (which was adviced) and loaded the project.
I have no experience with PSoC Creator yet.
I obtained the full firmware source code, and would like to edit and compile it.
However, we would like to maintain and compile the firmware ourselfes. cyacd files (110KB) and it all works fine. I have a handheld device that contains both the ARM® Cortex®-M3 CY8c5866 and ARM® Cortex®-M0 CY8C4247-BL chip.